AUTO LIFT FEATURES

• A variety of track lengths from 26’ to 48’.
• Heavy duty 50,000 – 100,000 lb. capacities.
• Surface mounted, recessed or flush mounted.
• Rolling air-hydraulic jacks available in 25,000 lb. or 50,000 lb. capacities for wheels free service.
• Full undervehicle access for all trucks, buses & heavy equipment.
• Full 63” lifting height on either surface or flush mounted model.
• Full and clear, unobstructed under-the-vehicle access without structural cross brace, or torsion bar.
• 12 position mechanical safety locks in all legs starting at 24”.
• All lifts are plumbed for air lines in the runways, prewired for florescent runway lighting, no separate 110V power supply required for added options.

AUTO LIFT DESIGN BENEFITS

• The heaviest built parallelogram in the world for your heavy duty lifting requirements.
• Large 7 3/4″ cylinders equal more power, lower PSI and longer component life.
• Self lubricating composite bearings with chrome plate pivot pins for maintenance free operation.
• Sturdy base design minimizes stress on the shop floor, allowing installation virtually anywhere.
• No structural cross brace (torsion bar) between the platforms; eliminates a trip hazard and the antiquated technology of a mechanical brace between the platforms.
• Hydraulic safeties throughout consisting of pressure compensated flow control valves and velocity fuses.
• Designed to eliminate binding and service issues of other parallelogram lifts.

HOIST CONTROL SYSTEM

• Computer controlled platform synchronization is programmable for different lifting heights; to accommodate various vehicles, low ceilings or different height technicians.
• Computer controlled dual high resolution, chain driven encoders monitor synchronous lifting and lowering 60 times per second.
• The computer’s alpha-numeric LCD display performs self test on startup, with information in plain english, with no flashing lights to be decoded.
• Control system user settings are input directly from the keypad or special settings are password protected. No outside computer is needed for reprogramming various settings.
• All platform switches and electrical sensors are located in the runway (not the shop floor). Continuous electrical runs from the lift’s console eliminating splice connections in the shop floor (found on other lifts).
• 24 volt control circuit provides operator safety during control console operation.
  Manual pump and valving allow lowering in a no power situation.

View More Images of This Lift on the Mohawk Lifts PR Site

Safety Locks

Control Panel

Starter Box

Base Design

Space Savings

Flush Mount

Clear Work Area

Please visit the Architects Section for all specifications.